Sonifex RB-MA2G Dual Microphone Amplifier with Gain Control

Vendor: Sonifex
Sonifex RB-MA2G Dual Microphone Amplifier with Gain Control With two separate low-noise microphone pre-amplifiers, the RB-MA2G can drive lengthy lines from microphones to mixing equipment or convert microphone level signals to line level....
$695.00
Title

Sonifex RB-MA2G Dual Microphone Amplifier with Gain Control

With two separate low-noise microphone pre-amplifiers, the RB-MA2G can drive lengthy lines from microphones to mixing equipment or convert microphone level signals to line level. It also has front panel level controls and metering. The rear panel houses all of the connectors. The microphone input is electronically balanced and of the XLR-3 type. Potentiometers with preset recessed positions allow for individual adjustment of the input gains. A 12-segment LED meter indicates the audio level for each channel, and two front panel potentiometers allow for level adjustments within ±12dB. It is possible to feed both balanced and unbalanced equipment with the electronically balanced XLR-3 line output by grounding the non-phase signal. There are separate switches for each channel that regulate a high pass filter (which rolls out low frequencies at 125 Hz) and supply phantom power (+48 V) to the attached microphone. The power supply connection is shown via an LED power indicator on the front panel.

Key Features

  • Neutrik XLR connectors.
  • Mic input gain adjustment.
  • +48V phantom power.
  • High pass (rumble) filter.
  • Front panel level adjustment.
  • Front panel LED metering.

Audio Specifications

 
Maximum Input Level: +4dBu
Maximum Output Level: +28dBu
Input Impedance: 2kΩ Nominal balanced
Output Impedance: <50Ω Balanced
Low Frequency Roll-Off: 125Hz @ 6dB/octave
Gain Range: Adjustable 12dB to 80dB gain
E.I.N:             -128dBu, 20kHz BW, max gain, Rs=200Ω
Distortion:                       <0.01%, +8dBu, 20Hz – 20kHz, 40dB gain, 20kHz bandwidth
Common Mode Rejection: >66dB @ 1kHz
Phantom Power: 48V
Frequency Response: 20Hz to 20kHz +0/-0.2dB
   

Connections

 
Input: 2 x XLR 3 pin female (Balanced)
Output: 2 x XLR 3 pin male (Balanced, can be unbalanced)
Mains Input: Filtered IEC, 110V-120V, or 220-240V switchable, fused, 9W maximum
Fuse Rating: Anti-surge fuse 100mA 20 x 5mm (230VAC)
Anti-surge fuse 250mA 20 x 5mm (115VAC)
   

Equipment Type

 
RB-MA2G: Dual microphone amplifier with gain
   

Physical Specifications

 
Dimensions (Raw): 48cm (W) x 10.8cm (D) x 4.2cm (H) (1U)
19” (W) x 4.3” (D) x 1.7” (H) (1U)
Dimensions (Boxed): 58.5cm (W) x 22.5cm (D) x 7cm (H)
23” (W) x 8.9” (D) x 2.8” (H)
Weight:           Nett: 1.35kg Gross: 2.0kg
Nett: 3.0lbs  Gross: 4.4lbs